I was processed by gold jewelry and started to do it. There is a problem that the golden ear relics are welded on a small golden ball. How to weld it? I do not know. The rate of waste is too high. Either the needle welded, or the small ball was burned. How to do? Is there any way?
3 thoughts on “I was processed by gold jewelry and started to do it. There is a problem that the golden ear relics are welded on a small golden ball. How to weld it? I do not know”
Leave a Comment
You must be logged in to post a comment.
Point water borax, the amount should be less, try to only point the welding place, and the more borax flows where the heat is heated, it is easy to melt. The fire should be concentrated to the welding place. The size of the size will increase and melt fast and melt. Try to keep the two temperatures as much as possible, that is, to burn a little to the large volume. This is a technical work.
Hello, you can use high -quality welded welding, basically no waste rate
Burn the Golden Bangli directly with the bottom of the musket and will become a small ball.